Skip to Content

SENDER HTTP_AAE Sender adapter Parameters issue

Mar 05, 2017 at 04:32 PM


avatar image

Hi All,

We have a requirement where we are receiving HTTP request to our PO (PO 7.5) Server and the incoming request may have more than 6 URL Parameters. I can use Dynamic Configuration to yield the actual incoming values and that is not a problem, but I have gone through SAP Help and it says that we have a limit of only 6 parameters...Any help would be highly appreciated.

SAP Help:

Referred to many threads but all seems to talk about RECEIVER HTTP_AAE Channel:

One is:



10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

2 Answers

avatar image
Former Member May 07 at 09:36 PM

Hi Anuj

I am facing the same issue, I have > 6 URL parameters in my HTTP_AAE Sender adapter.

Did you find a solution for this?

Best regards,


Show 1 Share
10 |10000 characters needed characters left characters exceeded

Hi Wilbert,

I think we never found the solution to this problem, and we had gone to REST Adapter instead.


Eduard Karaulov Jul 25 at 08:39 AM

For using more than 6 URL parameters in the HTTP sender adapter you need to make next settings (like in the HTTP receiver adapter settings):

1) activate the “Set Additional Parameters” option (see screenshot below)
2) add entries in the Additional Parameters table as described in a table below

  • Name
  • Value
  • urlext
    • urlext01
  • param7
    • urlext02
  • param8
  • 3) activate adapter

    Now we can test our settings. For this purpose I used Postman.

    After we've sent a message we can check PIMON (received message Dynamic Configuration part)

    image.jpg (138.5 kB)
    image2.jpg (71.5 kB)
    image3.jpg (138.9 kB)
    Show 1 Share
    10 |10000 characters needed characters left characters exceeded

    Hi Eduard,

    Many Thanks for this.

    We had actually gone with REST when we had faced this issue. will try this in coming requirements..