Lo cockpit---doubt plz

[Former Member]

Hi All,

i have changed a Datasource in Lo cockpit...by adding a field to the extract structure

and then i even regenrated the datasource in Dev as well and then activated it now after the change its green and i even checked the datasource in rsa3

now my doubt is when importing it to production.

i will lock the users

make sure no updating is being done

keep all the queues empty (extraction and Delta)

and then import i think i am on right track

so my question is as i have already done the regenerating of the datasource after changing the extract structure in dev and attached it to the request.

so do i need to again regenerate the datasource once i import the request is it necessary or else i just import the request with changes and then check the datasource and just start the V3 update and then replicate it in BWPRD becoz i have already regenrated thedatasource and activated it.

below i am giving the list of the contents in my transport, ( JUST TO CONFIRM I HAVE ONLY ADDED A FIELD TO THE EXTRACT STRUCTURE FROM THE RIGHT PANE TO LEFT IN MAINTANCE SCREEN)

<b>TMCEXACT---100MC13VD0ITM

TMCEXCFS---MCVBRK -- RFBSK (This is the field i added MC13VDITM

Active version of Datasource--2lis_13_vditm and a table with --ZZMC13VD1ITM</b>

How to Stop the V3 update where can i find the option....if i am not wrong...is it the one in lbwe with a pencil mark after the datasource name.

am i right. plz confirm

thanks and regards

harish

Message was edited by: H.B

[Former Member · Accepted solution]

Hi,

Yes, you don't have to regenerate the datasource in Production system after transporting the request.

To stop the V3, you should deactivate the extract structure on lbwe.

Hope this helps.

[Former Member]

H B

Just to confirm again you are on right track. Just transport your changes from Dev to Production system in R/3 side, when you do next delta in BW you will get for the new fields data in your next extraction.

Hope this helps

Thanks

Sat

[Former Member]

Hi All,

thanks for the confirmation...it all went well.

when assigning points it was giving error...as soon as its clear i will assign points. thanks

thanks and regards

harish