Skip to Content
avatar image
Former Member

Reading Local values of Parameter id

Dear all,

Would be thankful & rewarding if someone could let me know how to read the LOCAL value of a parameter id.

e.g. Case

1. Open a material batch using transaction MSC2N and Check the values of the parameter ids MAT (Material) & CHA (Batch) in debugging mode and then continue with the transaction. - Session 1

2. In another session - Session 2 - Display a Material Batch different from the one used in step one. Check the values of the parameter ids MAT(Material) & CHA(Batch) in debugging mode.

3. Now go back to session one of Step 1 and check the values of parameter ids MAT(Material) & CHA(Batch) again in Debugging Mode. You will see each of the parameter ids with two values one labelled as G (Global) & L (Local) with values of Session 2 & Session 1 respectively. When you use the GET PARAMETER ID syntax to read the values , it reads G (Global) value of the parameter id. How can i read the L (Local) value of the parameter id ??

Cheers

Nitesh

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    May 29, 2006 at 01:19 PM

    Hi Nitesh,

    As far as I know, you can't. The Global/Local indicator is by my knowledge a feature of the debugger only. Parameter IDs are created in the SAP memory per user only once.

    Regards,

    John.

    Add comment
    10|10000 characters needed characters exceeded

  • May 29, 2006 at 01:20 PM

    i dont think you have local and global parameter ids.

    Cheers,

    Abdul Hakim

    Add comment
    10|10000 characters needed characters exceeded