cancel
Showing results for 
Search instead for 
Did you mean: 

CLIENT_RECEIVE_FAILED for SOAP

dhanudjro
Participant
0 Kudos

Hi Experts,

We are facing issue after our SAP QA system got refreshed recently.

All the SOAP messages flowing from SAP to PI are failing with below error. SFTP and RFC messages are good.

Please note that there are no changes from PI side since 2 years and it was working fine before SAP system refresh. using PI 7.5/PO.

Accepted Solutions (1)

Accepted Solutions (1)

dhanudjro
Participant
0 Kudos

Thank you all for your support. We found that, during refresh of the system with production system, few config under Intergration engine configuration in the Tcode sxmb_adm are copied from production, we could change it back and the issue is resolved now.

Answers (2)

Answers (2)

Sriram2009
Active Contributor
0 Kudos

Hi Rao

Follow the thread, post system copy/ Refresh steps

https://answers.sap.com/questions/13526746/sap-po-system-copy-guide.html

Regards

SS

Ulrich_Schmidt
Product and Topic Expert
Product and Topic Expert
0 Kudos

It looks like after the upgrade the SAP system is now using different P/S/A values when sending these SOAP messages. Two solutions might be possible:

  1. Investigate the SAP side to find out, what caused these changed values and how to revert it back to the original behavior. (If a standard SAP component is used for sending the messages, you could open a support ticket under that component and let them check, whether anything change incompatibly in the upgrade.)
  2. Change the configuration on PI side to use the new P/S/A values instead of the original ones.
dhanudjro
Participant
0 Kudos

Could you please help me, where can i see these values in SAP and PI/PO.