IDOC transfer using ALE

[ravishshetty_r]

I have configured two r/3 systems for to transfer idoc.

the idoc is generated successfully but it is not transferred to the destination port.

The idoc status is 30 :IDoc ready for dispatch (ALE service) .

ideally it should come as 03:Data passed to port OK

Am I missing some configuration ? Kinldy advise.

Thanks

Ravish

[ferry_lianto · Accepted solution]

Hi Ravish,

Please goto <b>SM58</b> and check if the IDocs are stucked up on the t-rfc queue. If so, you can right click and choose Execute LUW to release them.

For other solution, you can use program <b>RSEOUT00</b> to pass the IDocs to the port.

Again, hope this will help.

Regards,

Ferry Lianto

Please reward points if helpful.

[ravishshetty_r · Accepted solution]

Thanks a Lot for your Help. Its working now. The problem, was that while defining the RFC destination the language was not maintained. Now the issue is resolved.

If you can send some link where is i can look more on the configuration of ALE, it will help me in my work.

Best Regards

Ravish.

[Former Member]

I had the same problem, what a very obscure cause for the problem!!!

[Former Member]

Pete,

I have the same problem. Where do I set language for an RFC destination?

Please let me know.

Thanks,

Sneha

[ferry_lianto]

Hi Ravish,

Glad the problem was solved.

Please check this online document for ALE and IDoc.

http://help.sap.com/printdocu/core/Print46c/en/data/pdf/BCMIDALEIO/BCMIDALEIO.pdf

http://help.sap.com/printdocu/core/Print46c/en/data/pdf/BCMIDALEPRO/BCMIDALEPRO.pdf

http://help.sap.com/printdocu/core/Print46c/en/data/pdf/CABFAALEQS/CABFAALEQS.pdf

http://help.sap.com/printdocu/core/Print46c/en/data/pdf/BCSRVEDISC/CAEDISCAP_STC.pdf

http://help.sap.com/printdocu/core/Print46c/en/data/pdf/BCSRVEDI/CAEDI.pdf

Also check this links for additional information.

http://help.sap.com/saphelp_erp2004/helpdata/en/dc/6b835943d711d1893e0000e8323c4f/content.htm

http://www.sapgenie.com/sapgenie/docs/ale_scenario_development_procedure.doc

http://edocs.bea.com/elink/adapter/r3/userhtm/ale.htm#1008419

http://www.netweaverguru.com/EDI/HTML/IDocBook.htm

http://www.sapgenie.com/sapedi/index.htm

Regards,

Ferry Lianto

Please reward points if helpful.

[ferry_lianto]

Hi Ravish,

Please check the partner profile (<b>t/code WE20</b>).

Perhaps the output mode was setup to trigger by background job instead of immediately.

Regards,

Ferry Lianto

Please reward points if helpful.

[ravishshetty_r]

Hi Ferry Lianto,

The outbound mode is set to Transfer IDOC immediately, and inbound parameter is also set to Trigger immediately, but the problem still persists. And the current status is still 30. if its transferred and recieved at the receiver port, then the status should be set to 03. Which doesnot happen. Please advise