Skip to Content
avatar image
Former Member

Message Interface do not show the Message Type

Hi All,

I have imported project.DTD file in External definations. Project.DTD file inturn references few other dtds. So i have imported all dependent dtd's in External definations.

When i click on Message Interface, try to choose Message type for Project, i do not see Message types.

Kindly help.

Thanks & Regards,

Gowri

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    May 26, 2006 at 11:28 AM

    Hi Gowri,

    what have you chosen as category for your External Definition?

    What did you choose in the field 'Messages'?

    What do you see when you change to the WSDL-tab?

    Greetings

    Stephan

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi,

      When i open the DTD in XML editor, it shows some error. This could be the problem.

      Thanks Moorthy and Stephen for your help.

      Warm Regards,

      Gowri

  • avatar image
    Former Member
    May 25, 2006 at 05:41 PM

    Hi Gowri,

    Did you activate the External Definition after importing the dtds.. otehrwiese activate it

    Also check that these dtds are imported correctly by clicking on Messages tab in the External Definition

    Then go to Message Interface and look for External Definition and select specific one

    Thanks,

    Moorthy

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Gowri,

      Probably your DTD is incorrect. check with any xml Editors , validate it and try to reimport the same. If you don't have proper message structure you cannot see the messages in teh Message Interface..

      Thanks,

      Moorthy