Skip to Content
author's profile photo Former Member
Former Member

multiprovider

Hello,

I have created a Multiprovider with two cubes . When I check the Result from the querry created from it ..

I have two key figures Each is having restricted key figure of the respective cube ..

The data is shown only for one cube..

It contains similar characteristics (identification) and I have assigned the same.

There is a date Billing date with is not derived by TIme conversion it comes from ODS to cube I have matched the same for both the Cubes..

Nimisha

Add a comment
10|10000 characters needed characters exceeded

Related questions

1 Answer

  • author's profile photo Former Member
    Former Member
    Posted on May 18, 2006 at 08:52 AM

    Besides performing the identification have you checked the selection tab for the characteristics in the multiprovider definitions?

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.