SAP EWM Monitor filters

[former_member804409]

I need to set a filter on available stock to display quantities less than 1. Currently due to UoM conversion issues decimal quantities are left behind and user need to clean up later. These are really small qty and we need a way to display them through a saved variant or something similar where user can simply go and extract details abt bins and qty. Any thoughts are greatly appreciated.

[former_member788724 · Accepted solution]

Hello

You can create new node and selection variant for your new node.

Once you have created new node, set selection criteria for the new node.

Using dynamic selection, you can fill more fields as per your need. Like I filled available QTY <1

Now once you open this new node, you can see the results.

If you want you can also set that selection pop up should not come once opening the new node.

Regards

ASLAM

[former_member804409 · Accepted solution]

Thankyou Aslam, I had already tried out that option but everytime i close monitor and open again, click on custom node that i created, my selection is gone. Thats where i am stuck. Any suggestions?

Regards,

Khushboo

[former_member788724 · Accepted solution]

for me, selection is not gone.

Did you setup the above steps mentioned.

I run again, it was okay.

[former_member804409 · Accepted solution]

First issue that i notices is I don't have option to set dynamic selection at custom node level therefore i followed a different route.

This option was only present at available stock node for me so i did as below-

I went to available stock and selected dynamic filter-

[former_member804409 · Accepted solution]

Then saved variant name and description as test. I did not select any additional criteria from screen.

[former_member804409 · Accepted solution]

Here in my custom node i tried to assign variant test but my results are still for quantity more than one

[former_member804409 · Accepted solution]

Could you point out here what i could have done differently here?

Thankyou so much Aslam for trying to help with my issue.

Regards,

Khushboo

[former_member804409 · Accepted solution]

Another thing i tried is to run my report at available stock level and tried to select option for my custom node, still result is not what i expected-

[former_member804409 · Accepted solution]

hey Aslam,

Any insights on the information that i shared?

[former_member788724 · Accepted solution]

from the screen i see that you have done 'selection selection criteria' for 'available stock' node. You need to do this for your newly created node.

[former_member804409 · Accepted solution]

Once you choose dynamic selection, did you try saving the variant or just selected "Apply selected Items"

[former_member804409 · Accepted solution]

Every time i reopen my node, my dynamic selection is gone-

[former_member804409 · Accepted solution]

It worked, after all these steps, i again had to assign variant. Thanks alot Aslam for your help.

Regards,

Khushboo