Skip to Content
avatar image
Former Member

Delivery address _ Attribute ADDR_SHIPT

Hi experts

We have maintain plant wise addresses in the tab "Edit Internal addresses" and asssigned the delivery address numbers to the attribute ADDR_SHIPT in PPOMA_BBP.

However when we are creating the shopping cart it pick up the default address maintained in the Edit Internal Address where there is radio button for default address.

can we deactivate that radio button and direct that the address should be picked up from the attribute ADDR_SHIPT.

This is required so that when user creates a SC the address is defaulted from the ADDR_SHIPT.

We have tick on as default in PPOMA_BBP - ADDR_SHIPT attribute.

Can some throw light on this,

regards,

Nimish Sheth

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    May 16, 2006 at 12:59 PM

    hi experts

    has any one face similar issue.

    regards,

    Nimish sheth

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Nimish,

      you can try to load R/3 addresses in SRM with the same number as in R/3. But as usual, we can have problems with number ranges. The risk is that your address numbers from R/3 are already "consummed" by SRM addresses.

      Anyhow, when transfering address data to R/3 (if you have activated it or using a SP where it is std), you can try to send the SRM address number, but you need a logic in R/3 to see if this address exists or not.

      That's why you should have a look at this thread (Ship-To Address not trasferred to backend) where I listed all OSS notes related to the transfer of addresse to R/3. Especially one, where a consulting solution is proposed to map address numbers between SRM & R/3 to avoid creating mass of addresses in R/3 during PR or PO creation.

      Rgds

      Christophe