Skip to Content
avatar image
Former Member

Development components

Hi,

i followed steps mentioned in the link below

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/docs/library/uuid/3fc1e590-0201-0010-7e8e-eca71476785e

i am not abel to get view1 i am getting only view2.

is there any custome code we have to write?

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    May 16, 2006 at 06:03 AM

    Hi Murali,

    I could not see anything in the link..

    However, I feel you need to go to View properties and make it default. But only one view can be a default view. So you can create a viewset and embed the 2 view in different view areas and then make both of them DEFAULT...

    Hope I answered ur Question...

    Lokesh

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 16, 2006 at 10:48 AM

    hi murali,

    How is the Viewset u have created?I mean is it similar to the one depicted in the link?

    Regards,

    Np

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 16, 2006 at 11:59 AM

    Hi Murali

    NO, there is no custom coding in this scenario.

    You are not getting the view1 of DC1 since you may not have added the reference "Used DC" or "Used Webdynpro Component" correctly.

    You create a Viewset - Right click the Window Node and select Create viewset.Then Right click on the upper part of the viewset cell (1,1) - select embed view the select "Embed Interface View of a Component Instance".

    You will find DC1 view there in the wizard.

    Hope this solves the problem.

    Regards

    Ananda

    Add comment
    10|10000 characters needed characters exceeded