cancel
Showing results for 
Search instead for 
Did you mean: 

Navigational attributes not being populated

Former Member
0 Kudos

Hi,

I am facing problem when I am creating CVCs. Here is what I have done:

This is my structure: I have one core characteristic in product dimension (Lowest level) and one core characteristic (lowest level) in location dimension and 3 navigational attributes for each dimension. While creating the core characteristic in both dimensions, I tagged the respective three navigational attributes in attributes section. The core and navigational attributes are tagged respectively in infocube as well. Transformations are created for these two core characteristics as info objects targets and data in the info cube / info objects is visible for all the levels. When i created MPOS, the attributes are visible in the navigational attributes tab. However, after creating the CVCs for lowest level, when I want to display the CVCs, I am not able to see the navigational attributes. I could only see the lowest level.

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi Lenin,

In your Infocube screenshot for navigation attributes,I can see that the a flag is not marked!

It should be active in RSA1. Can you please try to activate the POS again using /SAPAPO/MSDP_ADMIN.

PS: you only need to reactivate and NOT deactivate else it will lead to data loss.

This should correct the above inconsistency.

Hope this helps.

Thanks & Best Regards,

Sonali

Answers (1)

Answers (1)

Former Member
0 Kudos

Please find some of the relevant screenshots here

infocube.jpgmpos.jpgcvcs-creation.jpgcvcs-display.jpg