Skip to Content
avatar image
Former Member

created DCs not visible in Inactive sources.

hi all

I created several DCs from my local machine and checked it in but i m unable to view them even in the Inactive DCs hence they dont appear in Active Sources as well. Can anyone help me out on this?

Thanks a lot.

regards

vln

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    May 15, 2006 at 11:11 AM

    Did you check them in ?

    Were you connected at creation time ?

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 16, 2006 at 07:22 AM

    Can you see them in the DTR Web UI?

    Sometimes you need to refresh the NWDS Views, try clicking the Refresh button in the topright corner of the Inactive DCs view.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 16, 2007 at 02:31 AM

    Could you tell me how to solve this puzzle because I have the same problems. Thank you very much

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Try reinstalling NWDS, but make sure your installation source is located in the the root directory of a drive. The SAR extract creates a very deep directory structure. If it's too deep (because you didn't extract to the root of a drive), the installation will end prematurely without any error message.