cancel
Showing results for 
Search instead for 
Did you mean: 

Error occurs while Previewing or Printing Label

ashish25bp
Participant
0 Kudos

Hi,

While previewing or Printing the Label from CBGL_MP01, I am getting this strange error. It shows that the report not released for Generation Variant ##, but infact we re-released it again. Still not sure why the system is not able to find the released report and throws this error.

RGV setup checked and is fine. The issue occurs for few Materials only. But I compared with the materials that are working fine also compared the RGV's , DG master data, specifications, label stock; almost all... but nowhere I can find any discrepancy.

This error pops up as soon as we hit the preview or print button. Note that the label is determined correctly and can be seen in the label tree.

Accepted Solutions (0)

Answers (5)

Answers (5)

ashish25bp
Participant
0 Kudos

This issue is resolved.

One specification was marked for deletion and the material assignment was still there. Similar material was used in another spec for which the label was being generated. Though the report had W7 status for current spec, the system used to check the W7 status in the older Spec and give the message as ' Report not released for RGV'

To address this issue, the deletion indicator was set for the material assigned in the older (deleted) spec.

But thank you for your important suggestions.

satya11719
Active Contributor
0 Kudos

Hi ,

Report release process depended on your RGV also , you need to accept the report 3 times to release it .

I'm not sure how did you configure in your Genvariant, once it is completely released it will goto CG54 , that's your final report used in Label creation .

Best

Satya

ashish25bp
Participant
0 Kudos

Hi Satya,

Thanks for the suggestion, yes I already tried with that but the issue remained same (CG50).

But one thing is noticed that while releasing the report by clicking ' accept ' button in report management, I am not getting the popup as shown here but reports gets released. Whereas for other specifications I am getting this popup when I click on ' accept ' as it moves to Release status. And no error is encountered while reviewing those labels.

That means that released report for a specific material is not getting detected in CBGL_MP01

And yes that's true, I will sure mark my previous question but still they are open.

satya11719
Active Contributor
0 Kudos

Hi Ashish ,

You need to create raw report via create report function in CG02 , then release in CG54 , then you can able to generate the label using that raw template .

I hope this helps , please mark as correct for your previous questions , if the answers are helpful. It will help others as well.

Best

Satya

holger_hartung
Contributor
0 Kudos

Hi,

are you able to debugg this error? Maybe you have UserExit or indi. logics implemented?