on 02-21-2017 10:07 AM
Hi all
Is there a way to mark a whole sample/inspection point as invalid or as an outlier instead of going into each individual MIC and marking them with the attribute as invalid/outlier. The business do not want to do this as there may be 10 parameters so is costing them time where they just want to mark whole sample as invalid and then take a resample. They want to mark as outlier as do not want the results appearing on the certificate. Note this is before the Usage decision has been completed.
No, not that I am aware of.
Craig
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
No, not that I am aware of.
Craig
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.