Focused Build - Project not linked to SOLDOC branch

[shubhra_prasad]

I have created a release cycle for development branch of my solution.

I created a project, linked it to this release, then I set the sprint, wave and project to 'Released' status.

However, I don't see the Solution Documentation branch linked to it. It's empty.

Also, if I create a requirement and then work package then this project doesn't show up in the planned project field to assign this requirement or work package to it.

Any suggestions?

[DoloresCorrea]

Hello Shubhra,

I tried to give all the required steps to set up the scenario in this wiki page

https://wiki.scn.sap.com/wiki/display/SM/First+steps+to+work+with+Focused+Build+for+SAP+Solution+Man...

Please if you "release changes" from the import to the Desing branch. Are you creating the Requirement from the SOLDOC Design branch?

Best regards,

Dolores

[shubhra_prasad]

Hi Dolores,

Thank you for replying. The wiki is very helpful and I checked my setup as per that and all looks fine.

Yes, I am creating requirement from the design branch.

I had set my project to released so that should have been visible in the planned project section of the requirement. But it doesn't appear on the list there. Also in work package, when assigning it to wave/project, it doesn't show up.

Somehow, even though project is linked to release but it doesn't show the solution documentation branch scope.