on 04-17-2021 11:04 AM
Dear all,
System
Question:
Is it possible to separate standard and custom content?
I want that into the learning centre only standard connent should be avialable, but into the carousel only custom
I tryied to turn on/off control Standard SAP Content, but it didn't help me
thanks
Sure. Just don't have the two Workareas 'extended'. You have the Standard Workarea connected - specify that in the learningAppBackendUrl and (most importantly) learningAppWorkspace parameters. Then make sure your Custom Workarea is NOT 'based' on the Standard Workarea, and specify this (Custom) in the dataUrlSEN / dataUrlSEN2 parameter(s). (I don't know how the serviceLayerVersion factors into this - I'd think you could leave it as EXT and the above would work (as they WAs are not actually connected to each other). In theory you could use WPB (which would work for the Carousel), but I don't know how that would affect content retrieved from the learningAppWorkspace.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Dirk
I didn't understand what I had to do 😞
I did what you said but with any results (manager WA screen attached)
WA NCOC NV contains simulations that were created by our authors
I want to separate this simulations and sap standard content
I tried different combinations of settings, but without result in carousel and learning centre always the same content (not separated).
my current settings attached. In carousel and learning centre only my content.
Hi Dmirty Novikov,
Where we can find the Web Assistant Settings in S/4 Hana On Premise system
Thanks,
Sangamesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sangamesh
I haven't experience in settings Web assistant for S/4 Hana On Premise system. But I think you will wind it in web assistant manual
If under Additional Content > Display Learning Center you set the Enable Now Workarea ID to sap (which is the WA ID of your connected standard workarea) that should do what you want, no?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I looked in to browser console I have 2 requests
Is that correct?
I think it should be only request #1 (wa jdfb4c2a6) according to my settings
requests why I see only response from #2
Ah, OK I see what you are trying to do. Initially I thought you wanted YOUR 'help content' (Tiles and Guided Tours) but STANDARD 'learning content' (Simulations / Books & Book Pages). I now see from your comment earlier today that you want YOUR simulations (only) to show on the Learning Page, and the STANDARD (only) content to show in the Learning Center. Which is not possible (sorry). The Learning Page (of the Carousel) and the Learning Center basically pull information from the same place - which is the 'Additional Content' workarea in your definitions. So in your case (now) you are still seeing a call to the sap Workarea because it is pulling information for the Learning Page. (You should see ONLY STANDARD content on the Learning Page as per your current definitions, though...).
All I can suggest given this limitation is that you add a Link Tile to the Carousel that provides a link to your simulation (you can add an icon to differentiate it from regular help tiles). But that is all manual work.
User | Count |
---|---|
4 | |
3 | |
3 | |
2 | |
2 | |
2 | |
2 | |
2 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.