tcode- mm01 is giving error

[former_member654428]

Hi All,

I am trying to enter the tcode - mm01 , but it is giving me the error - Material Master maintenance not possible (KSTATUS IS BLANK). I have attached the error screenshot. I am new to Material Master (beginners level). Please suggest the steps to resolve this error.

img-20210408-121201.jpgRegards, Nikhil

[DominikTylczyn]

Hello nikhil.bagde

The message you experience is MG032. It's long text reads:

Short Text
Material master maintenance not possible (KSTATUS is blank)

Diagnosis

This error should not occur. The entries in system table T130O are incorrect.

Procedure

Contact your system administrator.

Apparently T130O tabel content is not correct in your system. It's hard to help you more without access to your system. I'd put a break point on the message and try to debug the code to check the source of the message.

Best regards

Dominik Tylczynski

[former_member654428]

Hi Dominik,

Is it possible that I can share my screen with you?

[TammyPowlas]

Hi - please review the resolution steps in SAP Note https://launchpad.support.sap.com/#/notes/0001775991 (logon required)

[DominikTylczyn]

The note 1775991 - Order / Notification Status is blank is about order/notification status, not about material master maintenance status.