Skip to Content
avatar image
Former Member

Message Split using BPM for Multiple SOAP Receivers

hi,

I have a scenario where in i have to split the message coming from IDOC(SOURCE) to multiple SOAP(TARGET) receivers through BPM

I took a single file as a scenario and tested it. It worked fine.

I am using only a single output interface.

I have followed this weblog

/people/sudharshan.aravamudan/blog/2005/12/01/illustration-of-multi-mapping-and-message-split-using-bpm-in-sap-exchange-infrastructure

but this blog has 2 output interfaces whereas in my case i just only one output interface that i want to route to multiple receivers based on the value in the PARVW in the IDOC.

Thanks,

Tirumal

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Apr 26, 2006 at 01:12 PM

    I think you do not need a split here.

    You can do content based routing on pARVW field in the reciever detrmination.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Apr 26, 2006 at 01:14 PM

    Hi,

    You can route the message in receiver determination depending on the condition. Check this weblog for more information.

    /people/shabarish.vijayakumar/blog/2005/08/03/xpath-to-show-the-path-multiple-receivers

    Thanks,

    Prateek

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Bhavesh Kantilal

      hi,

      Thanks for all your responses.

      I referred to the blog that you have suggested earlier and it provided me with good information to figure out the steps.

      Thanks,

      Tirumal