Skip to Content
avatar image
Former Member

Multiple Receivers and BPM

hi,

I have confiured multiple receivers in the Conditional Receiver determination. Its a IDOC -> XI- > SOAP scenario.

For each SOAP receiver an exception handling or error notification should be emailed.

1) Should i need BPM?

2) What are all the steps that would require in BPM?

3) Should we need a MAIL adapter to send these error notifications or can we use ALERTS?

Thanks,

Tirumal

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Apr 24, 2006 at 01:15 PM

    Hi,

    You can use alerts in BPM to handle this.

    Thanks,

    Prateek

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi,

      Refer these blogs:

      /people/michal.krawczyk2/blog/2005/09/09/xi-alerts--step-by-step

      /people/michal.krawczyk2/blog/2005/03/13/alerts-with-variables-from-the-messages-payload-xi--updated

      /people/sap.india5/blog/2005/12/06/xi-ccms-alert-monitoring-overview-and-features

      /people/aravindh.prasanna/blog/2005/12/24/configuring-scenario-specific-e-mail-alerts-in-xi-ccms-part-2

      /people/michal.krawczyk2/blog/2005/09/09/xi-alerts--troubleshooting-guide

      regards

      Suraj

  • Apr 24, 2006 at 01:29 PM

    Hi,

    If the requirement is to send an email whenever there is a problem in any of your interaface/ components, you can always configure alerts and use them without BPM.

    But, if your scenario is such that you are already using a BPM, then you can also trigger ALerts from the BPM. But, let not Alerts be the only reason that you are usinga BPM.

    To create Alerts, Alert Rule, just check this blog,

    /people/michal.krawczyk2/blog/2005/09/09/xi-alerts--step-by-step

    It will help you in doing your entire Alert Configuration.

    Next,from SP14 onwards, activation of end to end monitoring is not needed for Alerting. Refer to this note 870232 for this info.

    Next, to test if your Alerts have been defined correctly, go to SE38. In the program , type RSALERTTEST and then click on EXECUTE button ( F8 ). In the next window, it will ask you for your ALERTCATEGORY. Just give the name of your ALERT CATEGORY and click EXECUTE.

    If you have configured your alerts correctly, you will receive a message that tells ALERT IS GENERATED and will give the ALERT ID.

    Now, go to your Run TIme workbench and then select ALERT INBOX and see if you have got the ALERT message in your ALERT INBOX.

    If this is working fine, then the last step, implement the note 913858.

    If you are below SP14, also check this blog,

    /people/michal.krawczyk2/blog/2005/09/09/xi-alerts--troubleshooting-guide

    Regards,

    Bhavesh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Tirumal,

      There are tow ways to achieve what u want.

      1. If u don't want to use the BPM then you have to use SAP to send the Alerts to the required required recipient in a mail. For this you have to configure your SCOTT.

      2. If you don't want to use the mailing system in SAP then you will have to use BPM if you want to send mails for alerts raised.

      Regards

      VIjaya