cancel
Showing results for 
Search instead for 
Did you mean: 

Enable "Rules and Validations" in Custom BO SAP C4C

0 Kudos

Hi experts.

May be is a simple thing but i do not know where to enable the "Rules and validations" in the adaptation mode un SAP C4C.


I would thank you so much if anyone can help me to achieve it.

Regads.
Luis Angel

Accepted Solutions (0)

Answers (1)

Answers (1)

former_member226
Employee
Employee

Hello,

Such KUT/Personalisation properties for Custom BO can be enabled using so-called "Anchors" in the UI Designer for the respective UI components. Open the respective custom UI in UI Designer. Now Go to the Properties tab and select the "Component" from the properties content and choose "Anchors" --> Add a new Anchor --> Click OK. Repeat the same step for each Section Group as well as UI Field. Save and Activate your changes.

add-anchor-1.png

add-anchor-2.png

add-anchor-3.png

Now start again the Adaptation Mode and changes will be visible. You should be able to see the "Add" button for "Rules & Validations".

BR

0 Kudos

Hi saurabhkabra2009, Thank you for your answer, it helps me a little bit, beacuse i add anchor for floorplans and pane containers but i am not able to add "rules" for "UI COMPONENT" in OWL neither my EC. I need to enable or disable buttons depending on UserRols.

In the others UIs it is working...

Any idea why it is not working in OWL and EC??

Regards.

Luis Angel.

former_member226
Employee
Employee
0 Kudos

Hmm.. I am not sure about that. May be you need to check with SAP Support.

arthur_pretto
Explorer
0 Kudos

You can also check the following technical Articles: How to dynamically control a field behavior on a custom screen

Note that is important to know that creating an UI rule for a custom screen while on Adaptation Mode is not possible.( KBA 3108808 - UI Rules and Validations not available for custom screen.)

Best Regards