I ran a redwood bpa job chain and I had to kill a job that was running, then when the job got killed, the chain went said Manual restart requested, select restart option. I assume this is because of the status handler but the only restart option I found was if I right click on the root job chain, there is a restart option. If I select it, where will it restart? I would like to continue(restart) on at the next step after the step that I killed. I seen further down the chain, the steps before the error had the option restart from this step, but I want the chain to restart at the step after the error and when I right click that step I don't have the option to restart from that step.