Dear All,
I have configured LOSC with Pick Point. When I am doing Full Pallet Picking, Full Pallet goes to Pick Point, which is correct as per Configuration.
Then I change the Configuration (Refer attached Screenshot – LOSC) to check other Scenario and have an Issue with Partial Pallet. Scenario is -- > I need Picking for One Full Pallet and one Partial Pallet. When I pick a Full Pallet, it should not move via Pick Point and should directly go to Staging Area, and when a Partial Pallet is required, this should move to the Pick Point and I pick the required quantity and Leftover Quantity is moved back.
With this Configuration, when Task is created both Pallets (Full & Partial) directly goes to Staging Area (Partial Pallet is not going to Pick Point).
During analysis, I found both Tasks are directly going to Staging Area may be because, When Task is getting created, Active Tick Mark is coming by default for Partial Quantity as well, but I am not sure why this is happening.
I am using S4 Hana 1909 Embedded System. Any suggestion how to rectify this Issue.
Regards,
Avdhoot