Skip to Content
0
Jul 06, 2020 at 10:26 PM

Utilize Full Page With - Table Header Behaving Differently Than Blank Cell?

38 Views

Document is Letter / Portrait mode.

This should be an 8.5 x 11 page.

I want the table to take nearly the full width of the page.

On the cell in the header, I set the width to 7.90" (after accounting for margins), which you can see it takes up the full width.

I want to do the same for the table within the report body, but when I set the width in the table header cell (merged) to 7.90", it expands the table very large and over into the next page.

I have to reduce the cell to 5" and then it looks like it is utilizing the full page. But the page width is 8.5, not 5 inches!!

Help, gurus?

untitled.png

Attachments

untitled.png (51.2 kB)