cancel
Showing results for 
Search instead for 
Did you mean: 

Modelling Integration Scenarios in XI

Former Member
0 Kudos

Hi Friends,

Iam trying to implement the weblog /people/siva.maranani/blog/2005/08/27/modeling-integration-scenario146s-in-xi (Modelling Integration Scenario's in XI).I going through the steps and tried to create them in Design time...But Iam stuck up at the Integration Scenarios..

I have created a Integration Scenario and defined two Actions in two Application Components. I have marked the first one as Start Action and second one as End Action. My problem is that Iam unable create a communication link between them.

As I select the two Actions and right click and select "Create Connection between selected Actions", it does display me the Message Interfaces that I assigned to the Actions. And also it doesnt allow me to mention the Interface Mapping. It is in display mode.

What is the Problem and How to solve that?

Regards,

Raju...

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi,

just check whether u have given ur message interface as abstract interface by choosing abstract option while creating interface and use those abstract interface in ur interface mapping.

hope this helps u

regards

jithesh

Former Member
0 Kudos

Hi Jithesh,

Thanks for the reply...

I have given the message interfaces as abstract as you said, but still the problem exists.

Again it is not showing the message interfaces in the communication link.

Regards,

Raju...

Answers (3)

Answers (3)

Former Member
0 Kudos

Hi,

Check this link, this is also describes step by step process to develop scenario using integration process.

/people/venkat.donela/blog/2006/02/17/companion-guide-to-integration-scenario

Thanks,

Prateek

Former Member
0 Kudos

Hi,

Check if you have created the mapping between correct interfaces. Check the namespaces, SWCV also.

Then before "Create Connection between selected Actions"

check whether the Integration scenario is in edit mode.

regards,

P.Venkat

former_member187587
Contributor
0 Kudos

Hi Raju.

You mentioned you are in display mode,shouldn't you move to edit mode in order to edit your buisness scenario?

On design time it is possible to build your buisness scneario from top to buttom meanning:

1.strat with defining your Buisenss systems .

2.Go down to action level and create from each action

the needed Data type,Interfaces etc.

3.Then make the connection (Async - the two actions will be seen like steps - first action will be in higher position then the end step. for sync scnario put them leveled.

Hope this will help.

Regards

Nimrod