on 01-08-2020 9:34 PM
I have performed the configuration to allow for inbound email processing. I added the profile parameters and activated/configured the SAPCONNECT service and it is using the port I defined in the profile. I restarted the system, but when I do a netstat -a I do not see that port as listening. I assume it should be.
Hello Mary,
Short answer: yes.
Double check the parameter "icm/server_port_X" that you would have created to open the port with protocol SMTP.
Regards,
Isaías
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello maryjane.steele2,
Please look at SAP note below which is going to show you how to configure your system and in the same SAP note there is how to test section
2203325 - Configuration of e-mail using SMTP (inbound) [Video]
Answer to your question please check SAP note : 607108 - Problem analysis when sending or receiving e-mails
Thank you
Yogesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
The issue was that the Outlook routing had not been perfomed. But Note 607108 was helpful for peace of mind that my config was correct.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.