I'm getting error and server not starting up?

[ansellsilvans]

Hi Team,

I got two errors in command System not initiated. Not starting task module and could not switch tenant to master.

one more thing i can see some errors in ee too.. I have attached both the screen shots. Kindly give me the solution to this error.

Thanks. Ansell

[Former Member]

Follow instructions at https://wiki.hybris.com/display/R5T/Trail+~+Preparation

[Former Member]

Follow instructions at https://wiki.hybris.com/display/R5T/Trail+~+Preparation

[ansellsilvans]

We’re sorry...

... but something went wrong. This is most likely caused by someone else currently running a system init or update, in which case your current session was destroyed. Please come back later once this process has finished

I'm getting this error while initialize. how to stop that process

[Former Member]

1. Please stop the server by pressing ctrl+c from command prompt from where you started hybris server. 2. Set ant environment by giving the command: setantenv on the same command prompt 3. Give the command: ant clean all 4. After you see the message: Build Successful, start the hybris server 5. Go to hAC (Admin Console) and intialize your system again and wait (do not close/refresh the hAC. It may take 30 mins to 60 mins depending on your laptop configuration) till you see the message: Initialization Finished. After that you should be able to navigate through accelerator pages (check https://wiki.hybris.com/display/release4/Multichannel+Accelerator+Quick+Installation+Guide#Multichan... for accelerator URLs)

[ansellsilvans]

I'm also getting cannot switch tenant to master

[ansellsilvans]

We’re sorry...

... but something went wrong. This is most likely caused by someone else currently running a system init or update, in which case your current session was destroyed. Please come back later once this process has finished

I'm getting this error while initialize. how to stop that process