Skip to Content

Data Replciation from MSSQL through SLT to ECC Guidelines

Hello Experts,

We need to load one table form MSSQL through SLT to ECC system. We are already loading the same table from MSSQL to HANA Data base.

As part this activity we are successfully established a RFC connection Target as ECC. But when try replicate the table replication is not happening.

Kindly provide the step by step guidelines on it.

Thanks In advance.

Kind Regards,
Raja.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Apr 27 at 03:58 PM

    in case of replication into ECC, the table must be already exists in target.

    Add comment
    10|10000 characters needed characters exceeded

  • Apr 29 at 11:01 AM

    Thanks Andrey for your reply.

    We already have Z- Table defined at ECC side. I set Z Table as target table in LTRS. After Start Replication activity I see initial data load in process but it is not moving data in to target Z TABLE in ECC.

    Can you please advise on settings I need to config or proecedure to follow.

    Regards,

    Raja.

    Add comment
    10|10000 characters needed characters exceeded

  • Apr 30 at 02:38 PM

    There're no special settings required.

    Check that you have 2 configurations: one per direction and both configuration are configured with flag "Allow multiple usage".

    Check application log for any errors?

    You all correct and no error I recommend you to open the standard SAP support ticket. Support will check if something indeed collected from source side.

    Add comment
    10|10000 characters needed characters exceeded