Skip to Content

M0410 Message execution for AES

Hello All,

I would like to know how the below two actions are achieved in GTS for Message execution to customs

1) While saving the customs declaration document we want to have the 'M' message getting executed automatically i.e. while saving. Is this achieved thru development or standard configuration? If yes where in config?

2) After we receive the I1560 response message from customs on the message that was executed for AES, we want to have the 'P' messages activated. Is this done thru development or standard configuration? If yes where in config?

Thnks,

RM

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

0 Answers