Advanced Planning tab not appearing in Material Master

[leon_cornelio1]

Hi,

I have activated Advanced Planning tab after the system conversion from ECC to S/4 HANA 1809.

But I am not able to see advanced planning tab in Material Master post the activation.

[leon_cornelio1 · Accepted solution]

Hi,

Have been able to resolve the issue.

Advance planning view is assigned in screen sequence 21.

Screen sequence was not assigned to the material type that i was doing..once the assignment was done.I was able to see Advanced Planning view.

[leon_cornelio1]

Thanks for the reply.

I have activated it.yet it does not appear when i create or change a material.

[JiePeng]

face same issue, can you share how to fix this issue?thanks!

[leon_cornelio1]

Advance planning view is assigned in screen sequence 21.

Screen sequence was not assigned to the material type that i was doing..once the assignment was done.I was able to see Advanced Planning view.

[rupesh_brahmankar3]

Hello,

New tabs in S/4 Product Master transactions - The Advanced Planning tab has been introduced in S/4 Product Master transactions. Please check in MM01 if this tab gets displsyed if not then check OMS2 setting for material type wise view selection.

Also check Advanced Planning -> Basic Settings -> Activate Advanced Planning and Scheduling is activated.

Please refer Wiki page on it.

S/4 Hana - Advanced Planning Product Master Data Skip to end of metadata

Best Regards,

R.Brahmankar

[JiePeng]

at the beginning, the advanced Planning and Scheduling tab is there; how to show the tab again?