Skip to Content

Numerator for Conversion to Base Units of Measure can only enter a value less than 5 in length

Shown below, actually 1 PNA = 1350000 PC, but it just can only enter 5 number. I want to know is there any way to change the length of column 'Y' ? Or any other way to slove this issue? Thanks for your help .

screen1.png (32.5 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Apr 10 at 07:16 AM

    Hi,

    It not possible to extend the Numerator for Conversion to Base Units of Measure more than 5 digits. We also faced this problem during master data migration and used the following approach.

    1. Adjust digits based on UOM ( 100 PNA = 13500 PC)

    2. Use alternative UOM which are similler to base UOM

    Best Regards,

    Lingaiah

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Lingaiah,

      Thanks very much for your information. Maybe i can choice just only the second method which you provided. Because according to method 1, it should be 0.01 PNA = 13500 PC, but it can't enter decimal in denominator.

      thank's again and best regards,

      Herman