varient configuration

[nandha]

hi gurus,

I have written an object dependency in that bom components should picked for planned order and production order according to sales order requirement.but after assigned the object dependency to the bom components.it does not pick the material that i have assigned the object dependency.rather than i take the components that i didn't assign.

[a__engfehr]

Yes please share your procedure text so we can troubleshoot it. Your selection conditions are not being satisfied for items 30, 40, 80 or 120.

[former_member424533]

I think you should check weather it is written with $self and $parent in the code,

for BOM material selection it should be $parent

[former_member193808]

Hi,

The configuration results shows as per BOM. It shows everything except, the OD you have assigned. So, the issue is with OD. Check the dependency formula you have written, this is failing.

Thanks

Prem

[Mahendran8888]

Hi Nandha kumar,

You verify the BOM item which is picked wrongly and what needs to be picked up. Compare SC rule of the both. So SAP is given where mistake is exist and you need to find as per the comparison result. And at the same time check once again what you choosen, because most of in my cases i have choosen wrong values or wrong values can be restricted with other material.

You may chose manually but while choosing other material default the different value in cu50. So you check first what is the values exactly assigned for the particular characteristics.

If it is correct then problem exist you should work on selection condition only. so correct selection condition.

Upto my understanding selecting one material can be defaulted different value in required charcterisitics. So Please understand this value may be restricted by another material.

Regards

Mahe

[ibrahemy]

Hi NANDHA,

Which component ?which item?

Plz share OD text

Regards

Muahmed

[rupesh_brahmankar3]

Hello,

Are object dependencies for selection condition?

This is a case, where no object dependency is executed in CU50.

Check into configuration profile application BOM used for explosion in CU41.

Please refer this document on it,

Introduction to Variant Configuration

Best Regards,

R.Brahmankar

[nandha]

Thanks really helpfull document