Skip to Content

Problem with meter reading tolerance limits

Hi Experts,

I’am new on the DM module and I’m having some troubles to customize the tolerance limits for readings on SPRO: Define Tolerance Limits for Validation Classes

I have customized the validation class as below:

With this I was expecting for the “06 - Tolerance limits (relative)” validation the following rule:

  • For a consumption between 0 – 9 with a deviation(+-) over 90% should be displayed a warning.
  • For a consumption over 10 with a deviation(+-) over 55% should be displayed the error and the “Automatically Locked” status for the reading.

But when I entered a reading with consumption over 10(In this case 17,661 and over de 55% tolerance), the error never occurs, neither the reading gets the “Automatically Locked” status.

It only shows de warning for the “0 – 9 tolerance consumption” disregarding the “over 10 consumption” that i have customized:

I have already made the customizing below to apply the 06 validation to the validation class that i want to use(0003):

Allocate Independent Validations to Validation Classes

Define Validation Parameters for Validation Classes

The validation class is also correct applied on the installation i’am using.

Am I missing something?

Does anyone know why its not being applied the “over 10 tolerance” for a consumption above 10?

01.jpg (22.7 kB)
01.jpg (22.7 kB)
02.jpg (39.2 kB)
03.jpg (15.1 kB)
04.jpg (21.8 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

0 Answers