SAP Key figure warnigs

[former_member594111]

Hi All,

We have following warning msgs

1)Calculation KFID1@REQUEST: Input planning levels have different attribute sets.

calculation-KFID1@REQUEST = IF(“KFID2@REQUEST”=0,0,“KFID3@REQUEST”/ “KFID2@REQUEST”)

2)Calculation KFID@PL: Calculation for KF KFID exists, but stored value is used

what if i want both stored and calculated values?

Any suggestion on this?

Regards,

Abhi S.

[ayanbishnu1981 · Accepted solution]

Hi Abhi

Based on your input, what I think, this is case where your KF expression for KF1 is having inputs from KF's that consists more than 2 different base planning level. AS per IBP design you are not supposed to have more than 2 planning level as an input to your KF expression calculation.

Even if you are using only 2 different KF's as an input to your calculation, but if any input KF is being used with the option a stored KF, in that case the system considers it as 2 different planning level. Hence even by using 2 KF's as input, you are technically involving 3 different planning level in your calculation and hence you are getting this warning / error while activation. The issue is not because of your request level calculation but because of your calculation at the base planning level or any other planning level.

What you can do is the following

Define a calculation logic at the base planning level of KF1 for both the inputs KF's that you want to use and then use those input Kf's in your expression at KF1.

Regards

Ayan Bishnu

[former_member594111 · Accepted solution]

Thank you Ayan, it helps