Skip to Content

Extra space added on Item# NC- and SW- inItem Master Data

Hello Experts,

We spotted that when we entered NC- OR SW- in upper case and press tab on Item Master Data, SAP will automatically add an extra space between NC and - OR SW and -

Same issue is not observed if we use lower case letters.

Would you please advise what might be the cause?

Our SAP B1 version is 9.1 (9.10.230) PL: 13

Please see images attached.

image.png is before we press tab after entering NC-

image-1.png is after we press tab (Extra space generated between NC and -)

Thanks in advance.

image.png (14.0 kB)
image-1.png (15.3 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Mar 15 at 05:01 PM

    Hi Tjandra Afandi,

    There are few saved strings which should not be used in the beginning of codes. Otherwise, you will experience such issues.

    One of the behavior about these strings is mentioned in SAP Note 735524.

    Please check whether the behavior is same if you use any other string than these?

    Hope it helps!

    Kind regards,

    ANKIT CHAUHAN

    SAP Business One Support

    Add comment
    10|10000 characters needed characters exceeded