Skip to Content
avatar image
Former Member

Supplier Managed Inventory - PO number range

Hi,

In SMI scenario with replenishment order, is there any way we can match PO number range from ECC system while creating RO in SNC.

I am finding it difficult to match the current number range in ECC with SNC PO (created by RO).

Thanks,

Vaibhav

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Sep 16, 2016 at 04:41 AM

    Hi Vaibhav,

    There is no standard way of checking the current PO number range in ECC, while creating a RO in SNC.

    Normally we create a separate number range for SMI PO and then create same number range in SNC. This will automatically make sure that both POs number are in sync in ECC & SNC.

    Dont use this number range for any other scenario, this will again create same problem of inconsistency.

    Regards,

    Rahul

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 16, 2016 at 06:56 AM

    Hi vaibhav,

    In ECC system ,you can check the below path for RO  number range.

    spro->Material Management->purchasing->Purchase order->Define Number ranges here you can check the intervals.

    From SNC system you can check number ranges in SNRO tcode there you can check the ranges for  objects(/SAPAPO/R-//SAPAPO/R+).

    Thanks&Regards,

    Vishnu

    Add comment
    10|10000 characters needed characters exceeded