NLS deletion phase rowcount mismatch

[former_member192489]

We are steeping up a test to archive an Infoprovider that contains uncompressed data.  When an archiving request is made and we run the Check, the processing proceeds until the deletion phase where it returns the error "Simulation of selective deletion returns different number of data records".  Does anyone know why this would be the case?

[surendra_p · Accepted solution]

Hi Edward,

We recently implemented NLS and we also faced same issue while archiving data.

This issue may be because of the infoprovider problem try to check using RSRV t-Code if it fine then check the current version of your system and implement the following SNOTE -1915830.

For reference please go through the following link.

https://apps.support.sap.com/sap/support/knowledge/preview/en/1915830

Regards

Surendra

[Former Member]

Hi Edward,

This may be due to when simulating the selective deletion, the number of data records that were archived was found to differ from the number of data records that were deleted with the current deletion condition.

Please follow the below SAP NOTE it might help you on this.

https://apps.support.sap.com/sap/support/knowledge/preview/en/1915830

Thanks!

Satya.

[former_member273900]

Hi Satya/Edward,

We have the same issue with HANA Optimized cubes and I have tried the above option but no luck. I also noticed that few SIDs are not available in SID table but in FACT table.

Could you please help on this topic.

Regards,

Kushal