fleet management -ifcu not enable counters

[Former Member]

Hi all,

In IFCU Transaction code i am unable to enter the counter reading please check the below image and please let me know where and how to get it.

[Former Member · Accepted solution]

Hello,

Kindly post screen shots of Measuring points & counters for kilometer & fuel, created against your equipment: AP09AA3666

Regards,

Prasanna

[Former Member · Accepted solution]

Dear Prasanna,

Please check the below images and please let me know any changes.

[Former Member · Accepted solution]

Hello,

Cross verify your configured special measuring position and measuring position maintained in to MP. i.e. TIPPER-TIME or TIPPER-FUEL

It seems there is a mismatch due to which you are not able to have option to enter fuel readings.

Hope all other necessary configurations are available.

Regards,

Prasanna

[rakesh_kushwaha · Accepted solution]

Hi,

Have yo defined measurement Position in Configuration? Under

PM&CS>> Master data in PM&CS>>Technical Objects>>Setting of Fleet Management.

The same Measurement Position have to be Enter Measurement Point/Counter in Equipment master data.

Then only Counters/measurement Point will be reflected in IFCU Transaction.

Pls refer

Define Special Measurement Position. In your case define same measurement position TIPPER-DISTANCE, TIPPER-FUEL as a special position  under this config.

in Measurement Point IE02

IFCU

Please try once.

Regards,

Rakesh

[Former Member · Accepted solution]

Dear Rakesh,

Thank for your reply got the solution.

[rakesh_kushwaha · Accepted solution]

Pls mark thread Answered by Rewarding point if helpful.

Regards,

Rakesh

[psr2412]

Hi Yadav,

Refer below useful link on " How to enter readings"

https://scn.sap.com/thread/1593400

refer below screen shot  and check accordingly.

regards,

PS R

[Former Member]

Dear PSR,

Thanks for replay i have done the configuration but still i am unable to get the screen as editable.