Delete init delta

[former_member298288]

Hi experts,

I have deleted by mistak a init delta from the datasource 2lis_11_VAITM.

There will be any impact if I run another init without transfer data?

Thank you so much.

[Former Member]

hi,

I have deleted by mistak a init delta from the datasource 2lis_11_VAITM.

this would have delete the delta tab from infopackage and data source from RSA7.

if you run init without data transfer, then delta gets enabled, but with no historic data.

if you still need data, then , you can run inti with data transfer (assuming you didn't refill your setup tables with special selections after doing it first time) then run delta.

[former_member298288]

hello,

Wen I have deleted the init delta , the data still coming into LBWQ.

the second delta with the new init without transfet will get all data in LBWQ ?

[former_member210321]

Hi,

LBWQ goes on receiving data if you delete the init or not.

In your case you have deleted init, the data that came from LBWQ to rsa7 (LBWQ to RSA7 the data is loaded through jobs that is scheduled in LBWE) and which has not been loaded to BW has been disappeared due to deletion of init. When you reinitialise init rsa7 show the mark of delta again it start receiving the data from LBWQ.

As i said earlier you have missed the daily records which was there in RSA7 until the run of another init.

Please see the link below to get a glimpse of LBWQ --> RSA7 --> BW

https://wiki.scn.sap.com/wiki/display/BI/Logistics+Extractors+Data+Flow+from+LBWQ+or+SMQ1+to+RSA7+in...

AM

[Former Member]

Hi,

Init brings data from setup tables and delta bring from RSA7.

in case if you stop V3 update( LBWQ to RSA7), then you could have done inti without data transfer and then delta.

now with  you scenario, if you run init without data transfer (ex: on 12/08/2016 @ 3 pm) , what ever records posted in VB* tables after 3 pm considered as delta. if you are ok with this, then you can go-head and do 1) int without data transfer 2) delta.

[RamanKorrapati]

Hi,

please check at source side RSA7.

Whether your data source is exist or not with green status.

if not exist then you lost all the data what ever changes are happen after the success of your last delta load to till now.

if no data source at RSA7 then your v3 job(RMBWV311 ) will fail.

Thanks.

[former_member298288]

The data are always availables in LBWQ and not yet extrcacted into RSA7

I can run the program RMBWV311 to get data from LBWE?

[former_member210321]

Hi,

The impact would be you have missed the daily records until the run of another init.

To recover the missed records you have to restructure selectively on the missed records by date or by the number of the document if you know, and can load with another infopackage with type full.

AM