Crystal Reports XI R2 border formatting

[former_member601404]

Hey,

how can I fix issue from screenshoot?

]Thank you in advance.

[former_member205840 · Accepted solution]

Hi Lukasz,

What is the issue ?

-Sastry

[former_member601404 · Accepted solution]

As you can see [creport.png], the last row is not surrounded with borders. This row is on 2 pages, it starts on 2 and end on 3.

[former_member205840 · Accepted solution]

I see that it has come out from 'sa' section to 'sb' section so, it could be an issue.  Try to adjust the border within 'sa' section.

thanks,

Sastry

[former_member601404 · Accepted solution]

Ok, I have just adjusted all sections an it is OK, at this moment. How I can thank you?

[former_member205840 · Accepted solution]

Hi Lukasz...

Hahaha... no problem.  you can close this thread by choosing correct answer so, it will treat that it was resolved.

Thanks,

Sastry

[abhilash_kumar]

Hi Lukasz,

Please post a screenshot of the design page as well.

-Abhilash

[former_member601404]

It is attached [creport.png]

[abhilash_kumar]

This is the Preview Page, I need the Design Page to see how those lines are placed and on which sections.

-Abhilash

[former_member601404]

Sorry, here you are [designer.png]

[abhilash_kumar]

Hi Lukasz,

Try this:

1) Reduce the size of the section 'sb' so that it barely meets the horizontally line

2) Right-click the horizontal line > format > Check 'Extend to bottom of section'.

3) Right-click the vertical line and check the same option.

-Abhilash

[former_member601404]

didn't help. Is there an option to make CR to start page only with full row?

[abhilash_kumar]

Would you be able to send the .rpt file with saved data to my e-mail?

-Abhilash

[former_member601404]

False alarm I've just adjusted every setction and it seems to be OK. how can I thank you for help?