cancel
Showing results for 
Search instead for 
Did you mean: 

User and password for first access

former_member412214
Discoverer
0 Kudos

Dear group,

What is the user and password to access the ERP environment for the first time ?

I have read the document but I could not understand when it says the password is the private key downloaded , it is a code very large with too many caracters. Please help in this issue, I thank you in advance.

Regards,

Accepted Solutions (0)

Answers (3)

Answers (3)

Former Member
0 Kudos

Hi,

I have the same problem. I instanciated SAP S/4HANA, 1511 FPS 01 on Azure. Everything went well.  SAP CAL says it is active, green and I see connect button.

Then I downloaded SAP GUI 7.4.

Then I logged on to the system using first userid and password as explained in the setup guide delivered by SAP CAL. SAP GUI responds with correct screen but says password is wrong. After several tries I get of course the message in screenprint.

Too may tries. In my opinion this means user password combination as explained in set up guide from SAP CAL is not correct.

Please advise.

Regards.

stanimir_eisner
Employee
Employee
0 Kudos

Hi,

Which password did you use? For users DDIC and SAP* you should use the password provided when you created the instance in SAP CAL.


Best regards,

Stanimir



Former Member
0 Kudos

Hi,

The credentials to access the environment should be included on the setup guide.

Regards

adarshs_kapoor
Active Participant
0 Kudos

Hi Shilla,

We cannot do that for security reasons since, the user-guides are attached to the solutions and everybody can view them.

Each user guide has a dedicated section explaining how to connect to your solution instance based on the "type" of solution and you have to use your master password for all users (the one that you define while creating your instance).

Best regards,

Adarsh

former_member412214
Discoverer
0 Kudos

Hi Adarsh S Kapoor  ,

I have already done that you suggested . I have used the user that comes in the guideline with the password that I put when I have created the instance in SAP CAL, however it is not working either.

Give more instructions.

Thanks

stanimir_eisner
Employee
Employee
0 Kudos

Hi Joao Paulo,

What's the error message that you get?

Best regards,

Stanimir

adarshs_kapoor
Active Participant
0 Kudos

Hi Joao Paulo,

What solutions are you using ?

You have to use your master password that you defined during the instance creation.

Furthermore, in the Getting Started guide there's a section explaining how to access the solution and what user/passwords to use.

Best Regards,

Adarsh