Stock stuck in 1Q

[Former Member]

All,

I have a problem in a PRD system.

An inspection type 17 was used for incoming inspection. The Inspection Plan uses a fixed sample size of 1.  The inspection lot was created in ECC. The results recording and Usage Decision was done in ECC. The corresponding inspection document was updated with the UD code ACC with follow up action putaway. The stock is stuck in status 1Q despite the fact that the usage decision was done. This is happening for one out of the 10 HU's on the inbound delivery.

Question:

1. How do i move the stock from 1Q to 1F? The transaction code /SCWM/POST will not allow me to do this giving an error message that the stock is stuck in quality inspection

2. Has anyone seen this behavior in EWM-QIE?

I have also raised an OSS note with SAP. This incident has gone to the development team in Germany.

Thank you for your inputs if any in advance

Regards

Anup

[Former Member]

The following OSS notes need to be implemented to fix this:

EWM-QIE notes

2101237 Decoupling inspection document from EWM follow up processing

2134159 UD:”Stock posting Change” follow up action is not executed

2159984 Successful decision follow up processing returns to the queue

2200250 Sample item reference remains in stock

Fix stock in 1Q

1883065- ZQI_REFERENCE_REMOVE fixes the reference of stock in 1Q . After executing this report with the warehouse number and inspection document and entires check SCWM/AQUA and SCWM/QUAN entries in the output . First run this report in the simulation mode. Then use SCWM/POST to move the stock from 1Q to 1F.

These notes fixed the bug and corrected stock in EWM-QIE.

Regards

Anup