Skip to Content
avatar image
Former Member

configure idocs for User management ack settings?

1. IDOC config idoc says acknowledgments should not be requested, and run idx_noale ? why should we turn off and how to do this ?

2. IDOCs sent to IS should not be processed by IDoc adapter, advises insert the relevant idoc types into exception table, execute report idx_select_idoctyp_without_is

why we need to configure explicitly for each relavant ido types?

thanks

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Mar 07, 2006 at 10:16 PM

    Hi Kumar,

    >>>>>>IDOC config idoc says acknowledgments should not be requested, and run idx_noale ? why should we turn off and how to do this ?

    Refer to SAP Note 777175 in this regard.

    Rgds,

    Sam Raju

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 08, 2006 at 03:53 AM

    Hi Kumar,

    Receiver adapters that run on the Adapter Engine support system acknowledgments if they are requested by the sender. Acknowledgements are triggered when a message is successfully processed by the adapter or if an error occurs while it is being processed. Receiver adapters do not support application acknowledgments. The RNIF and CIDX adapters are exceptions to this rule, since they also support scenario-dependent application acknowledgments. Sender adapters of the Adapter Engine do not request any acknowledgments.

    This means, JDBC adapter does only send system acks, however IDoc adapter is requesting application acks. Therefore as mentioned by the previous poster, you have to disable acks for this scenario using report IDX_NOALE.

    Also go through these documents for any further help:

    http://sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/library/xi/xi-how-to-guides/how to handle acknowledgments for idoc.pdf

    http://help.sap.com/saphelp_nw04/helpdata/en/6a/e6194119d8f323e10000000a155106/content.htm

    I hope this clears all your doubts.

    Regards,

    abhy

    PS: AWARD POINTS FOR HELPFUL ANSWERS.

    Add comment
    10|10000 characters needed characters exceeded