Skip to Content
avatar image
Former Member

Assigning of new material to QM Inspection for a Goods Receipt

Dear experts,

I'm using the QM Inspection for a Goods Receipt already for couple of materials with a Z-Inspection Type and everything works just fine.

Now I have a new material in the system and I've already assigned this material to my inspection type by using of QA08 as well as I've assigned to this material an inspection plan...but when I'm booking Goods Receipt inspection lot will not be created...

Could anybody give me an advice what I could check additionally?

PS. By the way, when I assign the inspection type 01 to my material the inspection lot will be created. So the problem should be about my Z-inspection type. What can I check?

Thank you very much in advance.

BR

Denis

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    May 30, 2016 at 02:10 PM

    Hi Denis,

    Please check if the Z-inspection type added to your new material has "Active" indicator added or not. Else, if this Z-inspection type is already creating inspection lots for other materials, then for this material also inspection lot should have been created.

    Thanks,

    Arijit

    Add comment
    10|10000 characters needed characters exceeded

    • FYI - In case if the inspection lot origin 01 has two inspection types 01 and Z01 linked, but material master has inspection type "01 - NOT ACTIVE", whereas, "Z01 - ACTIVE", then that's sufficient for the process to work. The need for 'Preferred inspection type' comes up, only when more than one inspection types with same inspection lot origin is active in material master QM view. Then the system needs to differentiate which inspection type should be taken as a default choice.

      Hi Denis,

      In case if you have activated QM setup, after creating the PurOrd, then you can run a new scenario with your material 1010, Plant 1000, and let us know if still the same issue is there.

      Thanks,

      Arijit

  • avatar image
    Former Member
    May 31, 2016 at 04:05 AM

    HI,

    Apart from what mentioned here, additional you can check in your inspection plan, whether the task list usage is 'Goods Receipt', this can be one of the reason.

    With Regards,

    Prathamesh

    Add comment
    10|10000 characters needed characters exceeded

  • May 31, 2016 at 11:59 AM

    Hi Denis,

    Thanks a lot for  sharing the screen shot.

    You have not activated  "Preferred inspection type " indicator for the inspection type "Z01".

    Z inspection type will work only when Preferred  indicator is activated.

    Please activate the  'PreferredIns Typ"

    Regards,

    Vivek Malik

    Add comment
    10|10000 characters needed characters exceeded