Skip to Content
avatar image
Former Member

how to check if the adapter are working

I have completed all the steps as was mentioned in the document for file to file scenario using BPM . but i am not able to test it . basically the file should be picked up based on the poll interval but it is not happening . also the file adapter is not green . is there anything wrong with the adapater

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Best Answer
    avatar image
    Former Member
    Mar 06, 2006 at 11:38 AM

    Amit

    Can you check whether your File Adapter Status is " <b>ACTIVE</b> " or not.

    Also pls. check your Change list.

    Also try to use the Absolute path for your file location.

    Regards

    Lalit

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Please stop spamming all old threads in SCN each time you have an issue. If you haven't already done so, please read the The SCN Rules of Engagement

      Please read the following blog on why "reanimating dead threads" is not good community behavior.

      Dr. Frankenstein - please stop reanimating the dead

      If you have not found an answer after searching on SCN, please create a new thread, pointing out what's your issue, which threads you have gone through and provide as much details as possible. This will definitely help others to help point you in the right direction, rather than "shouting" out loud as many times as you can in the community.

      Rgds

      Eng Swee

  • Mar 06, 2006 at 11:56 AM

    Hi Amit,

    When you click on file adapter, you will get a list which is the name of the communication channel which you have defined. Are you able to find your communication channel here?. If not you have not activated it. Go to the configuration scenario right click and say activate. Go to the standard change list and make sure your communication channel is not one of the objects there, if it is there right chick on it and say activate. once this is done you must be able to see your communication channel in the adapter monitoring--> file adapter. Once this is done kindly see what is the error and post it here, so that we may be able to help you out.

    Regards,

    Chandra

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 06, 2006 at 11:07 AM

    Hi Amit,

    If the file adapter is not shown as green in adapter monitor then it means that there is some problem with the configuration you have done to the adapter. You'll get the info why the adapter has gone into error from the adapter monitor.

    Cheers

    JK

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Amit,

      I think you have probably not activated your communication channel.Just got to the change list and activate all the components that belongs to you.

      Regards,

      abhy

  • Mar 08, 2006 at 04:10 AM

    Hi Amit,

    Its nice to hear that your problem is sorted out at last..!! 😊

    Regards,

    Bhavesh

    Add comment
    10|10000 characters needed characters exceeded