on 05-25-2016 11:37 AM
Hi all,
For calibration process, I have assigned inspection type 14 to order type and assigned inspection point 300 in task list. but still inspection lot is not originated from maintenance order. In previous orders inspection lot is originated but ,its not originating now.
What could be reason for it.
Thanks
Vivek Varun
What about behavior in other clients Dev and Quality. If it is same then Try this
In customizing, remove Inspection type 14 against the Order type and Save. Now put it again and Save. See what happens? IF it resolves then transport this to PRD.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Check Inspection lot Number Ranges , if possible create one manual inspection lot.
Thanks& Regards,
Gopi.k
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
8 | |
7 | |
4 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.