Skip to Content

Issue in opening graphical calculation view editor

Hi,

I am facing issue in opening graphical calculation view editor. There are no error messages .

When I am trying to open 1 particular graphical calculation view, it is just showing blank page instead of all relevant nodes.

This issue is only for 1 single calc. view, rest other calc. views are working fine.

Please suggest possible cause and resolution for this issue.

SAP HANA Modeler perspective --> Calc. View open --> blank page

SAP HANA Version 1.00.096.00

SAP HANA Studio Version 2.0.13

Best Regards,

Avinash

CalcviewError.png (42.9 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    May 31, 2016 at 05:36 PM

    Hi,

    I have recreated the view and transported again to QA.

    Best Regards,

    Avinash

    Add comment
    10|10000 characters needed characters exceeded

  • May 23, 2016 at 06:23 PM

    Avinash,

    please try to open the calc view on the Developer perspective, Project explorer tab

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Sergio,

      Thanks for your response,

      I did not get any error or warning when I opened it in development perspective.

      Yes, I am able to open other calc. view from same package in development perspective.

      -Avinash

  • May 23, 2016 at 06:25 PM

    Hello,

    Can you check if you have the needed privileges to view the view in question?

    Also, the Studio revision you are using is quite old. I would recommend an upgrade (2.2.7 + maybe?)

    Also have you tried re-deploying the view again and re-activating?

    Michael

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Michael,

      Issue is in dev environment, where I have developed this calc. view.

      It was working fine after I developed and then transported it to QA box and it is working fine in QA.

      Next , i had done some changes in dev. version and after changing it activated fine without error then this issue occurred.

      Thanks,

      - Avinash