No creating of BP with MDG - General Data area not editible

[Former Member]

Hello together

we've installed a S4/HANA 1511 and have startet to config MDG8. After completing the standard config. guide for MDG 8.0, we're facing following problem, it's not possible to create a BP because the area 'Change Request' - 'General Data' is not editible, the rest is ok.

The change request ID is '0', it will be not changed or counted higher, I think here could be the problem,

Has anybody an idea?

Thanks for your support

p.s.

- It's not an authorization problem

- and it's not the 1st system I installed

Cahit Temizkan

Moderation: do not add your contact information!

[Former Member]

As I determined, It seems an FPM Problem,

The Problem occurs in the Feederclass 'CL_USMD_CR_GUIBB_GENERAL_DATA'

„ Component FPM_FORM_UIBB_GL2

  Component Configuration USMD_CR_GENERAL_DATA"

There is a Errormessage '‚Field ‚REPLIC_MODE‘ is not available in feeder definition'

The field 'Replic_Mode' is missing in the FPM Repository >> How can I extend or maintain the used repository of a FPM Component?

The access/check to the 'REPLIC_MODE' is done in the Interface Method 'IF_FPM_GUIBB_FORM~GET_DEFINITION' of the feederclass 'CL_USMD_CR_GUIBB_GENERAL_DATA'

But I couldn't find the area where the field definition is, to maintain it for this FPM Comp..

In other releases the repository has the correct entry for this.

THank you for your support.

Bye

Cahit

[Former Member]

[former_member201266]

Hi,

It seems like authorization issue, probably you do not have edit access.

The number will automatically selected if you are raising the request.

Thanks,

Cherry.

[Former Member]

Hi,

Please check 'USMD_CREQ' object in SNRO and make sure its starting with No '01'.

Regards,

Sudhir Wakodikar

[Former Member]

Thank you Sudhir,

I've checked it, it didn't start with '00'

The numberrage is defined with 000000000001 - 999999999999, current number is '51'

>> it seems the counter is counting, but in WEBDynpro the change request is showing '0'

Hope for further ideas

Greetings

Cahit

[Former Member]

Hi Cahit,

Please check the communicator setting.

Please check below thread also:

Change Request Number is not generated | SCN

Regards,

Sudhir Wakodikar

[Former Member]

Hello Sudhir,

thank you for your help, but could you pls. short explain how I can check the communicator settings?

In the link you posted is no description for this.

Bye

Cahit