Skip to Content
avatar image
Former Member

Ho to maintain entries in table : /SAPSLL/TCOTSU

Hi Team,

I found an error in the system while doing a transfer from GTS to ECC (Tcode: /n/SAPSLL/SWN_RTR)

It says : No SAP unit of measurement could be determined for supplementary unit "____"

I guess that there is an entry missing in the above mentioned table.

Please advise where do we maintain this?

Thanks

Kaushik

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • May 16, 2016 at 02:09 PM

    Hi Kaushik,

    The UoM are assigned to entries in ERP table T604.

    Regards,
    Dave

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 19, 2016 at 09:28 AM

    Hi Dave,

    Thanks for replying.

    Ok so you mean, this error has to be handled in the ECC and not in GTS?

    Thanks,

    Kaushik

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Kaushik,

      Here are a couple of additional things I would do on the same lines as Dave suggested to resolve it.

      1. Can you check the logs for the commodity codes upload within GTS? If there are no errors, it would mean your GTS system doesn't have an issue as all the files carrying the relevant UoM and supplementary units are loaded successfully.

      2. As Dave rightly suggested, verify the T604 or use CUNI transaction and verify the relevant UoM exists in ECC (use the internal measurement unit column value from table /SAPSLL/TCOTSU when you are trying to check in T604 and not the supplementary unit by itself)

      Hope it helps!

      -Shrini