Skip to Content

Report to run by Characteristic across multiple materials in one plant

Hi All

Hoping you can help looking for a report to run by characteristics across multiple materials in one plant.

QGP1 is quite nice except you can only run for one characteristic at time and if you take off the material selection in the results history it takes off the plant selection also so not exactly what we are looking for. The other one is QGA4 and using the Characteristics table Graph which is great the only problem there is the material code is not on the output. Does anyone have any ideas would be greatly appreciated e.g. what we want

MATERIAL - BATCH - LOT - CHAR - RESULT VALUE - VALUATION - CODE -TARGET VALUE - LOWER SPEC - UPPER SPEC- TEXT - SHORT TEXT

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • May 11, 2016 at 02:05 PM

    Hi Sinead,

    Have you tried QA33/QE51N? Ideally they should give you most of these information, but in a different view, where you need to go inside the inspection lot results for getting further details. Check if this helps.

    Thanks,

    Arijit

    Add comment
    10|10000 characters needed characters exceeded