Skip to Content
avatar image
Former Member

Should an inspection lot (QALS) always have an entry in QAMV

Dear Experts,

I would like to know when will the entries in QAMV table be populated ? Does this happen at the time of Inspection Lot (IL) creation ?

Also can you please let me know if all Inspection lot will have at least one entry in QAMV. If not ,the scenarios where there need not beany entries in QAMV.

Thanks,

Rajesh.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    May 09, 2016 at 01:07 PM

    Hi Rajesh,

    Yes, at the time when inspection lot is created with REL system status and updated in QALS, at the same time QAMV table is also updated with the specification linked to QALS. Details form inspection plan, QMAT data, MARC data, QPMK data, etc are flicked to QAMV while this entry is created. Creation of QAMV entry for any inspection lot is only one time, and once an entry is created, no details are changed later.

    If the inspection lot is created with initial status CRTD, that means inspection plan is not assigned yet. So though inspection lot is created in QALS, still there will be no entry for the same inspection lot in QAMV.

    If you have added additional Ad-Hock MIC in QE01 (complete copy model) for testing inspection lot, which were earlier was not added in the plan, then only these ad-hock MIC's will NOT BE REFLECTED in QAMV, as MIC addition has happened later then QAMV update.

    Thanks,

    Arijit

    Add comment
    10|10000 characters needed characters exceeded